Replacing Temperature Sensor - Dometic A552 Service Manual

- Position element, adjust its position. The element must be positioned in the
direction of hinge. (Fig. 65)
- Reinsert boiler-insulation, secure.
- Reinsert boiler-insulation cover, bend back blocking tabs. (Fig. 66)
- Reinsert temperature controller
- Snap back wire clamp of heating element. (Fig. 67)
Figure 65
- Reassemble loosened end of hinge
- Check electrical insulation resistance according to 2.3.3.

2.3.5 Replacing temperature sensor

- Remove electrical cover. (See 2.3.3)
- Push off flat sockets of temperature sensor from the flat connectors of
printed circuit board. (Sensor)
- Open refrigerator door, remove plugs from two bores of sensor cover in the
inner compartment, set aside. (Fig. 68)
- Unscrew screws of sensor cover, lift out sensor from cover. (Fig. 69, 70)
Figure 68
- Pull out sensor wire towards inner compartment carefully, so that the flat
sockets do not get jammed in the lead rubber gasket. (Fig. 71, 72)
Figure 71
Figure 66
Figure 69
Figure 72
16
Figure 67
Figure 70