Direct Time Access; Pause; Repeat Disc - Madrigal Audio Mark Levinson 39 Operating Manual

the reduced-volume audible scan available during these modes to search the CD
until the laser pickup reaches the passage you want to hear. (Assuming your CD
player is set for audible rather than silent scanning. If not, see Special Functions.)
As soon as you release the button, play resumes.
If you search past the beginning or end of a track, the laser pickup will move on
to the previous (or next) track. If you try to search forward past the end of a CD
or program, the laser pickup will stop at the end of the last track. If you try to
search backward past the beginning of a CD or program, the laser pickup will
stop at the beginning of the first track of the disc (or playlist).
Y ou may use

Direct Time Access

disc.
1. Select the desired track using either
2. Press
3. To begin play at that point, press
For example, if you want to begin play one minute and thirty seconds into track
2, select track 2 by pressing
press
elapsed time on track.) If you do not press
seconds (that is, it will "forget" that you had begun to do something, and revert to
normal operation).
Alternatively, you might want to set the Nº39 to play music for a specific period
of time. Say you' d like to listen to music until the evening news begins in 30 min-
utes. Make sure both the
ing time remaining on disc, the default display mode when in
enter
minutes from the end of the disc, and engage play at that point. When the music
ends, you will know it is time to turn on the news.

Pause

To suspend play while a CD is playing, press
point, press
If left in
laser will turn off (thereby enhancing the longevity of both). This
pause
mark (
mark mimics the double bars used to indicate
Alternatively,
pause
To repeat (continuously) all tracks on a CD, press

Repeat Disc

LED is lit. To return to normal play, press
on the Remote Control to begin play at a specific time on the
time
on the Remote Control.
numeric keypad
time , then press the numbered buttons corresponding to
when you would like play to begin. (The numbers you select will
appear in the portion of the display .)
time
Note: The time you select depends on the selection you've made
with the display mode button: elapsed or remaining, CD or track.
on the remote control. Press
2
. (This example assumes that the most recently used display mode was
play
time on disc
; and press . This sequence will direct the Nº39 to a point 30
3 0 0 0 play
again.
pause
for about two minutes, the transport will stop spinning and the
pause
mode will be indicated by the display showing a slowly flashing quotation
) as a reminder that you are in the
||
may be engaged by pressing and holding the
extended pause
button until the double bars begin to blink.
and or the
next previous
.
play
, enter
time
, the Nº39 will timeout after ten
play
and LEDs are on (indicat-
time remaining
stop
pause . To resume play at the same
mode (since this
extended pause
).
pause
until the
repeat
(or
repeat rpt disc/trk
, then
1 3 0
); press ;
time
extended
disc repeat
on the remote)
33