Setup And Installation; Connecting Ac Mains; Connecting Digital Audio Sources; Connecting The Digital Audio Outputs - Madrigal Audio Mark Levinson 39 Operating Manual

Caution!

Connecting AC Mains

Connecting Digital
Audio Sources
Connecting the Digital
Audio Outputs
30

Setup and Installation

For your protection, review "Important Safety Instructions"
before you install your Nº39.
Plug the female end of the AC power cord into the appropriate socket on the rear
panel of the Nº39, being certain to seat it firmly , all the way into the receptacle.
Double-check to make sure that the AC power switch is in the off position (the
side of the switch with an "O" should be depressed), and also that the voltage
indicated on your Nº39 corresponds to the normal voltage for your country . (Con-
necting a 120-volt Nº39 to a 220-volt AC outlet is not a good idea.)
Plug the male end of the power cord into the wall outlet, and then turn on the
power switch located on the rear panel of the Nº39 (by depressing the side of
the switch that has a single vertical line like this: "
The Nº39 incorporates EIAJ
two additional digital sources. (See Rear panel, Nº39.)
For optical digital interconnection, we recommend the use of better-quality opti-
cal eiaj cable. Your dealer can help you select an appropriate cable for your sys-
tem.
For electrical digital interconnection, we recommend Madrigal MDC cable. MDC-2
is designed for 75Ω S/PDIF
MDC-2 is available in various lengths from your Mark Levinson dealer.
Using appropriate cables, connect an output of each additional source (laserdisc,
digital tape, etc.) to the appropriate input on your Nº39.
The Nº39 incorporates aes/ebu
with either digital recorders or with outboard digital processors. (See Rear panel,
Nº39.)
For electrical digital interconnection, we recommend Madrigal MDC cable. MDC-1
is designed for 110Ω AES/EBU
designed for 75Ω interconnection (via either RCA or BNC connectors).
S/PDIF
Both MDC-1 and MDC-2 are available in various lengths from your Mark
Levinson dealer.
Using appropriate cables, connect the appropriate outputs on your Nº39 to your
external digital components.
| ").
optical and RCA digital input connectors for up to
interconnection (via either RCA or BNC connectors).
and s/pdif electrical output connectors for use
interconnection (via XLR connectors). MDC-2 is