Advertisement
BHM
8/1/13
NTV-Doc
9. Lay the back metal housing down with the circuit board facing up in the orientation shown, and
remove (3x) Phillips head screws:
10. From the NTX54-Ford kit, gather the sub-board with ribbons attached. Fold the main, bigger ribbon
underneath the board like shown below. You should see blue on both ends of this ribbon with this
orientation.
11. Gather the two, short harnesses
labeled 'TP-IN' and 'LCD-OUT' from
the NTX-54 Ford kit. Take note that
the white connectors on one end of
each of these are different sizes.
:
Agreement
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
8 |
P a g e
Advertisement
