Advertisement
BHM
8/1/13
NTV-Doc
14. Replace the factory Ford circuit board. The NTX54-Ford circuit board needs to be palced on top.
Connect the wider ribbon that was tucked underneath the board from step 10 and the touch panel
ribbon to the factory Ford circuit board like shown below. Use the extended screws provided with the
NTX54-Ford kit to secure both PCB's down to the metal chassis.
This hole
This hole
must remain
must remain
clear
clear
Be certain that the ribbons
are seated fully and
squarely. Failure to do so
may result in hardware
damage.
15. Flip the modified LCD housing upside down,
and place the LCD panel just above the housing.
This will make reconnecting the factory ribbons
to the new NTX54-Ford PCB easier:
:
Agreement
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
10 |
P a g e
Advertisement
