Advertisement
BHM
8/1/13
NTV-Doc
2. Separate the two halves of the assembly by pulling
straight up after the screws have been removed. Set the
back half of this LCD assembly aside. Note that the center
connector is keyed and the halves can only be replaced in
one direction:
3. On the LCD panel housing, mark across the brackets
and the housing to make replacing later a breeze:
4. On each side (left and right) of the LCD
housing, remove (2x) Torx T8 screws, and
(2x) Phillips head screws:
5. Next, remove (2x)
Phillips head screws on
the top and bottom of the
LCD housing:
:
Agreement
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
6 |
P a g e
Advertisement
