Included Trickle Charger Model Cca230; Optional Charger Model Csa640E - Entel HT446 Owner's Manual

2.0 TRICKLE CHARGER model CCA230 (CCA110 for 110VAC)
1. Connect the CWC640 AC
adaptor to the CCA230
charger pod. The LED
status light will illuminate
green indicating ready for
charge.
2. Turn the transceiver off.
3. Insert the battery pack
into the CCA230 pod, either with or
without the transceiver attached. The LED status light changes
from green to RED and trickle charge begins.
4. A fully discharged battery pack will take approximately 6 hours
to charge, depending on the remaining power condition. When
charge is complete, the LED status light turns green.
Note : The CWC640 AC adaptor can be replaced by the included CMC640
12v charger cable. Charge time remains at 6 hours.
2.1 OPTIONAL RAPID CHARGER model CSA640E
1. Connect the CSA640E to a
mains supply (110 to 230V).
When switching on, the
LED flashes orange briefly
to confirm self-diagnostic
test complete.
16
Figure 5. CCA230 Charger pod
Figure 5-1. OPTIONAL CSA640E
Rapid charger
DC12V
110-230VAC