Reception; Transmission - Entel HT446 Owner's Manual

VIB
Indicates vibrate mode enabled, the transceiver will Vibrate during the
initial call.
SCMB
Scrambler enabled. Feature only available in certain countries
CALL
Call alert feature. You may select one of 20 individual call tones.

1.7 RECEPTION

1. Turn the transceiver on by rotating the volume control in a clockwise
direction. A power on tone is generated after 1 second to indicate the
transceiver has passed its self-diagnostic test. Select the desired
receive volume level by further rotating the control clockwise.
After power on, the transceiver will always default to the last channel
selected.
2. Select the desired channel using the [UP/DOWN] buttons.
3. When receiving a signal the LED indicator illuminates green.

1.8 TRANSMISSION

1. Perform steps 1 through 3 of RECEPTION.
2. Before transmitting, monitor the channel and make sure it is clear.
3. When receiving a signal, wait until the signal stops before transmitting.
The transceiver cannot transmit and receive simultaneously.
4. Press the [PTT] (push-to-talk) switch to begin your transmission.
To confirm transmission in progress the LED illuminates RED.
5. Holding the transceiver 2 inches from your mouth speak slowly and
clearly into the microphone.
6. When the transmission is finished, release the [PTT] switch.
10