How To Clean - Hamilton Beach Walk-n-Cut Instructions Manual

5. Press the piercing lever all the way down to energize the
can opener and pierce the can. It is not necessary to hold
the lever down once cutting begins. Except for short cans
or cans with a small diameter, you can let the can opener
rotate freely around the top of the can without holding it.
6. The motor will automatically stop when the lid has been cut.
7. Raise the piercing lever to release the can opener from the
can. Carefully slide the lid from the magnet.

How to Clean

1. Unplug charger from electrical outlet
and from can opener.
2. Remove cutting assembly by rotating
the piercing lever counterclockwise
until it pops out of position.
3. Wash the cutting assembly in hot,
soapy water. Rinse and dry
thoroughly.
4. Wipe the body of can opener with a damp cloth.
5. To reassemble, place the knob on the back of cutting
assembly into the hole on the front of the can opener.
Push down and to the right until the assembly snaps into
place.
5