Other Adjustments And Functions Of The Remote Controller - Gree GWC09AA Installation And Service Manual

Other adjustments and functions of the remote controller

Timer function
The system is equipped with two Timer settings as there is the common Timer
and a Time pre-selection. These Timers can be optionally adjusted by the re-
mote control unit.
General Timer
If the system is switched off, the Timer can be switched ON. By reaching the
time preset, system restarts in the same manner as before the switch is off. The
interval of the Timer adjustment is half an hour and can be set from 0.5 up to 24
hours.
Timer function may be adjusted while system operation is in OFF position. As
soon as the preselected time is over, the system stops automatically. The inter-
val is even 0.5 hours, time setting from 0.5 up to 24 hours.
Clock Timer
Tripping the Timer ON when the system operates, it will continue operation. If
the system is de-energised, when the Timer is switched ON, it will restart after
the preselected time under the previously chosen conditions.
Putting the timer in OFF position in system standstill, it stays de-energised. In
case the timer is switched in OFF position during system operation, it will go on
until it reaches the preselected time set.
Timer Change
If the system is activated in a certain timer status (to be seen above) it can be
switched ON/OFF by pressing the corresponding key. Timer will be reset.
Putting the timer in ON, as well as OFF during system operation, it continues
operation into the preset time (Timer OFF) is over. Then it will stop automati-
cally.
If there are two timer sets for ON and OFF Timer during system standstill, it re-
mains disconnected until the ON Timer is reached. It is reinitiated after that.
Buzzer
Whenever the indoor unit gets a signal - pushing a button on the unit itself or on
the remote control unit – or by switching on, it makes a sound.
Sleep function
This function gives a selection of diverse graphics of preselected temperatures
for sleep time.
Turbo Function
This function may be set in COOLING mode.
Automatic Control of Fan speed
The system will automatically choose the speed of the indoor unit fan (LOW,
MEDIUM, HIGH), dependent on the ambient temperature.
GREE Service Manual GWC09AA / K5NNA6A Page 35