Turn Ans. Machine To Fax Transfer On; Turn Ans. Machine To Fax Transfer Off - Command Communications ComSwitch 8500-t Operator's Manual

Table of Contents

Advertisement

Turn Answering Machine to FAX Transfer ON
1. Plug a single line touch-tone telephone into PHONE port of the CS8500-t
2. Pick up the telephone handset (the PHONE LED will light)
3. Unplug power, then plug back in
4. The FAX LED will light to indicate access to the programming mode
5. Press
Enter additional changes (if desired)
6. Press
7. Hang up the phone
Turn Answering Machine to FAX Transfer OFF
1. Plug a single line touch-tone telephone into the PHONE port of the CS8500-t
2. Pick up the telephone handset (the PHONE LED will light)
3. Unplug power, then plug back in
4. The FAX LED will light to indicate access to the programming mode
5. Press
Enter additional changes (if desired)
6. Press
7. Hang up the phone
With this feature turned ON, the CS8500-t will monitor the line for 30 seconds after the answering
machine answers a call. If the answering machine disconnects during this time, the call will automatically
transfer to the FAX. To accommodate these timing parameters, your outgoing message should be no less
than 15 seconds, and no longer than 20 seconds in length. (Single cassette answering machines are not
recommended for use with this feature due to timing limitations of these types of machines.)
To disable the CS8500-t and retrieve your answering machine messages, follow these steps:
1. Dial your phone number and when your answering machine answers, press
tone phone. Follow the remote retrieval procedures for your answering machine.
2. After retrieving your messages, hang up. The CS8500-t resets for the next call.
CS8500-t Operator's Guide
(the TTY/TDD LED will flash three times acknowledging your changes).
again to end programming mode; the FAX LED will turn off
(the TTY/TDD LED will flash three times acknowledging your changes)
again to end programming mode; the FAX port LED will turn off
on your touch-
14

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ComSwitch 8500-t and is the answer not in the manual?

Table of Contents