Please Read Before Use - Earlex 6900 Operating Instructions Manual

SAFETY OPERATING INSTRUCTIONS

PLEASE READ BEFORE USE

The substances used with this spray applicator (paint, thinners etc) may contain hazardous,
harmful, explosive or corrosive materials.
l
The spray applicator must only be used with paints and solvents that have a suitable flash point
for spraying. If in doubt, consult the paint or solvent manufacturer's data
l
Always ensure there is adequate ventilation when spraying.
NEVER spray near an open flame, including an appliance pilot flame.
l
NEVER smoke when spraying.
l
Always disconnect the unit from the mains supply cleaning the spray applicator.
l
Always ensure the spray area is safe and free from all debris that may present a fire or trip hazard.
l
NEVER, under any circumstances, point the spray gun at another person or animal. In the
l
event of injury occurring, seek expert medical advice immediately.
l
NEVER allow children or unauthorised users to operate or play with the spray equipment.
This equipment is for professional use only.
l
Always read the paint manufacturer's thinning instructions before use.
Always wear the correct protective face mask when spraying. We also recommend wearing
l
gloves, goggles and overalls.
l
After every use ensure that you clean the spray gun thoroughly and grease the gland washer.
Use only genuine manufacturer replacement parts.
l
Only use the spray equipment as detailed in these instructions.
l
Do not use the air hose or mains cable to pull the HVLP unit.
l
Check the hoses, hose connectors and mains cable daily. Any worn or damaged parts should
l
be replaced immediately.
l
This appliance is recommended for household use only.
This appliance is not intended for use by persons (including children) with reduced physical,
l
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
l
given supervision or instruction concerning use of the appliance by a person responsible
for their safety.
WARNING: The substances used with this Spray Gun (paints, solvents, etc.) may contain
dangerous, harmful, explosive or corrosive materials. ALWAYS COMPLY WITH THE
SAFETY INSTRUCTIONS ISSUED WITH THIS PRODUCT AND THE MATERIAL BEING USED.
Only use the Spray Station as described in this manual.
TECHNICAL SPECIFICATION:
Wattage: 1100 Watts
Voltage: 120 V (60hz)
Air output: 22L/sec
Sound pressure level: 88 dB (A)
Maximum viscosity: 250DIN/sec
Fig.1
PARTS LIST
1. Air Cap Ring
No Description
2. Air Cap
3. Air Distributor Plate
4. 0.08" (2.0mm) Fluid Tip
5. Fluid Tip Seal
6. Pivot Screw
7. Washer
8. Main Body Assy
9. 0.08" (2.0mm) Fluid Needle
10. Adaptor
11. Needle Spring
12. Fluid Adjusting Screw
13. Pivot
Container capacity: 1 litres
Air hose length: 4.5 m
Dynamic air pressure: 0.30 bar
L0151 14. Flexible Tube Air Feed
Part No No Description
L0517 15. Gland Nut
L0162 16. Gland Seal (2 pcs)
L0157 17. Trigger
L0159 18. Centre Bolt & Pick Up Tube Assy
L0179 19. Yoke
L0195 20. Clamp Lever
L0180 21. Shim
L0166 22. Lid Assy
L0174 23. Gasket
L0175 24. Centre Bolt Nut
L0176 25. Paint Container
L0178 26. Filter (x2)
27. Air Hose
2
L0182
Part No
L0173
L0168
L0177
L0183
L0184
L0185
L0186
L0187
L0188
L0189
L0190
N0087
SG243