Event Search; File Management - Q-See QT Series User Manual

EVENT SEARCH

Selecting this tab will bring up a list of recorded events. Your NVR is configured by default
to record when motion is detected. You can choose whether to display events triggered by
Motion, Sensor or both. These files are saved as events.
Select the date you wish to search and click
the Search button. You will be presented with
a list of recorded events.
Select the channel and click the Double-click
the event file you wish to play back.

FILE MANAGEMENT

From within this tab you can lock, unlock or delete recorded events from the drive.
Clicking the Search button in the upper right of the window will bring up a list of events to be
displayed. Results can be filtered by selecting date and channels if desired.
LOCK – Selecting a file and then clicking the Lock button will protect the event from being
overwritten or deleted unless the entire drive is reformatted
UNLOCK – This will remove the file protection and the event recording can be deleted or
overwritten normally.
DELETE – If the event is not Locked, this will remove the selected event from the NVR.
NOTE! If the status shows "Writing" it means that the sector on the hard drive
where the file is located is still being written to. You cannot delete the file until
the file is completed and the word "Writing" disappears.
PICTURE 4-38
Image
PICTURE 4-37
51