Table of Contents
Advertisement
SWITCHING THE SECOND UNIT ON AND OFF
If the heater or cooler unit selected is LOCAL or REMOTE (operation with just one
unit), it is possible to switch temporarily the mode to BOTH without changing the
COOLER or HEATER unit in the configuration menu.
To switch the REMOTE unit on and off proceed as follows:
22º
21.2º
V1
22º
21.2º
Notes:
-
The ventilation speed will always be shown, even if the remote unit is not an
air conditioning or an air flow unit: this is because the local unit cannot know
the configuration of the remote unit.
-
If the remote unit has no ventilation, then changing the ventilation speed
will have no effect.
-
If the remote unit has ventilation, it will follow the same speed as indicated
on the local unit display.
-
You can define any type of unit for the local and remote units> any
combination is possible.
INTEGRATION WITH DOMOTICS
The A-TOUCH thermostats can be integrated in a home automation system,
enabling association with scenarios, remote switch on and off, both from a light
switch or your smart-phone APP. For that, the unit has to be connected to the
communication bus of the automation system.
CONTROL FROM AN AUTOMATION UNIT
Any automation unit, for example light switch, can switch the thermostat on and off
if they are associated and the right commands are sent. The commands have the
following function:
TOGGLE
ON/UP
OFF/DOWN
TIMER
DELAY
SCENARIO
Notes:
-
If unit is totally OFF, TOGGLE will not be able to switch the uit ON, only
AUTO OFF.
-
If the unit is AUTO OFF, TOGGLE will not be able to switch the unit
completely OFF.
-
TIMER has no meaning because the maximum time that can be set is 20
minutes, too less for climatization operation
-
The SCENARIO command is transformed into OFF/DOWN when all members
of the scenario are already on the scenario state. In this case, the
thermostat will switch from ON to AUTO OFF or AUTO OFF to OFF, depending
on the original state. In any case, the climatization is switched on.
info@a-touch.in.th
Hold the key
(VENT) for more than 1 second:
- the REMOTE unit will switch on, the actual ventilation speed is
shown.
switching between OFF and AUTO OFF or switching between AUTO
OFF and ON.
switch from OFF to AUTO OFF and switch from AUTO OFF to ON.
switch from ON to AUTO OFF and switch from AUTO OFF to OFF.
should not be used
switch from ON to AUTO OFF and switch from AUTO OFF to OFF after
the delay time specified
select directly the mode as defined in the SCENARIO
www.a-touch.in.th
Advertisement
Table of Contents
