Operation - A-TOUCH W-Thermo Instruction Manual

USING 2 UNITS WITH 1 THERMOSTAT
As explained above, it is possible to use one thermostat to control 2 different
climatization units. So that this is possible, the slave actuator (REMOTE) must be
associated with the master actuator (LOCAL) that is the unit that is connected with
the thermostat panel.
ASSOCIATING A REMOTE TO A LOCAL UNIT
To associate a remote unit with a local unit proceed as follows:
From this moment on, the units are associated.
Notes:
- The remote unit can only be associated with 1 local unit
SELECTING THE UNIT TYPE IN THE REMOTE UNIT
The remote unit must also be configured for the correct unit type it is connected to.
To select it proceed as follows:

OPERATION

The thermostat will operate normally and according to the settings in HEATER unit
and COOLER unit:
- With the local unit if LOCAL
- With the remote unit if REMOTE
- With both units if BOTH
- No operation if NONE
The operation is the same if the unit operates with a local, remote or both units.
info@a-touch.in.th
Press the key (PROG) on the remote unit to put it in programming
mode:
- the 3 LEDs go ON.
Press now the key (STBY) on the touch panel of the local unit:
- the 3 LEDs on the remote unit go OFF.
Hold the key (PROG) on the remote unit for more than 1 second>
- the red LED blinks the number of times as the selected mode:
1 = radiator
2 = radiating floor
3 = airflow2
4 = airflow4
5 = air conditioning
6 = Daikin FDX
Press the key (PROG) to select the next value.
- the red LED follows the selected type.
Confirm by pressing the key
- the LED goes off.
(TEST).
www.a-touch.in.th