Additional Settings - Mercedes-Benz Comand Operating Instructions Manual

The calculated route may include an area to
be avoided if:
your destination is located in such an area.
R
the route uses roads that lead through an
R
area to be avoided.
i
Highways within blocked areas are always
taken into consideration in the route
calculation.
Defining an area for the first time
Calling up the area menu
To switch to navigation mode: press the
X
Ø button.
To show the menu: press W the COMAND
X
controller.
Select Navi in the main function bar by
X
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
Select Avoid Area
X
confirm.
If you have not previously blocked an area,
a menu appears.
Select Using Map, From Memory
X
Personal POIs and press W to confirm.
If you select Using
crosshair appears.
If you select From Memory
Personal POIs, either the destination
memory or the list of categories for POIs
appears.
and press W to
or From
Map, the map with the
or From

Additional settings

Destination memory (
R
List of categories for personal POIs
R
( page 85)
Y
Select the desired destination or personal
X
POI and press W to confirm.
When the destination address is displayed,
X
select Cont. and press W to confirm.
The map appears.
The crosshair marks the center of the area
that is to be avoided.
To scroll the weather map: slide XVY,
X
ZVÆ or aVb the COMAND controller.
To set the map scale: as soon as you turn
X
cVd the COMAND controller, the scale bar
appears. Turning clockwise zooms out from
the map; turning counter-clockwise zooms
in.
Turn cVd until the desired scale is set.
X
To apply a block: press W the COMAND
X
controller.
A red square appears on the map.
To adjust the size of the square: turn
X
cVd the COMAND controller.
The square is enlarged or reduced.
To confirm the settings: press W.
X
The list appears. The previously selected
area to be avoided has been added and
activated.
You can also determine additional areas to be
avoided ( page 116).
Y
115
page 70)
Y
Z