Final Test - Cisco Spam Quick Start Manual

11
Test the Blocker
Use the system test to verify that the Blocker is running properly. On
the Next Steps page, enter an email address that is valid in your mail
server, and click Run System Test.
System Test
The system test checks Blocker for internet connectivity and basic mail handling.
Verifying internet connection...
Verifying MX record information...
Connecting to your Exchange Server...
System test complete. Check your admin inbox for a Welcome Message.
Whatʼs next?
Is Blocker Receiving Email?
Active Directory Configuration
A successful system test sends a welcome email to the account you
entered during the Blocker configuration. Check this account to verify
you received the email.

FINAL TEST

Send an email from a private email account (such as Gmail or Yahoo!
Mail) to your company email account. Click Monitor > Incoming Mail
to check your mail reports. If the Blocker processed the test
message, the email domain of your personal email account appears
in the Incoming Mail report.
Enter an email address that exists in your Exchange/Mail server:
Send email to your company account from a personal account like Gmail
or Yahoo!
Wait for your message. Within a few minutes, you should receive your
message.
Check Mail Reports. The email domain you used to send the test
message shold be listed in the Incoming Mail Reorts.
> View Incoming Mail Reports
Run the Active Directory wizard so that Blocker only accepts incoming
Just Got Easy...
email verified against the Active Directory server.
> Active Directory Wizard
Blocker supports configuration of other LDAP servers without a wizard.
- Cisco Spam & Virus Blocker -
If the system test
is successful, you
should see the
following message.