Configuration Summary - Cisco Spam Quick Start Manual

13

Configuration Summary

Review the following details of your configuration.
MANAGEMENT
You can manage your Blocker from the management port (Data 1)
by entering http://192.168.42.42, or via the IP address assigned to
your Data 2 interface after you have completed the System
Setup Wizard. If you reset your configuration to factory default
settings (for example, by re-running the System Setup Wizard),
you can only access the Management interface from the Data 1
port (http://192.168.42.42), so ensure you have a connection to
the Data 1 port.
Also, verify that you open firewall Ports 80 and 443 on your
management interface.
INCOMING EMAIL
After running the System Setup Wizard, your Data 2 port is
configured for inbound email and management settings are enabled
on this interface.
OUTBOUND EMAIL
After running the System Setup Wizard, your Blocker is configured
to accept inbound email. You can also configure it to relay outbound
email. For instructions on configuring outbound email, see the
Cisco Spam & Virus Blocker User Guide.
COMPUTER IP ADDRESS
Remember to change your computer IP address back to the original
settings that you noted in Step 3.
You must shut down your Blocker from the
System Administration > Shutdown/Reboot
warning
page to prevent corruption of your queue
and configuration files.
- Cisco Spam & Virus Blocker -