CarShow Installation Guide - Ford Mustang
PREPARING FOR THE INSTALLATION
Before you start, please read these critical steps below
BEFORE YOU START THE
INSTALLATION,
READ THIS GUIDE!
CHECK THE BATTERY
Test the battery voltage to make sure it's fully charged to
a minimum of 12.8 VDC
This only takes seconds and can save hours of
troubleshooting later.
TURN THE VEHICLE
Keep the Vehicle Off during the installation to avoid
setting various Vehicle Fault sensors
Keep the Vehicle OFF during the
Failure to follow this may cause the AIRBAG FAULT
SENSOR to become enabled. Dealer Service
Departments charge a significant fee to reset the Fault
Disconnect Negative Battery Terminal Before
Panel pry/removal tool
Various size Phillips screw drivers
7mm Socket
T10 Torx
CarShow
Installation Guide
OFF
installation
Sensor.
Starting!!
Tools Required For Installation:
STEP
1
Copyright 2013 All Rights Reserved
CS-MUST-IG Rev A
Page 2