Advertisement
CarShow Installation Guide - Ford Mustang
Rosen Radio Bezel
Re-install OEM Radio controls to CarShow radio bezel
assembly using 13 x T10 OEM torx screws that were removed
in previous step.
NOTE: 2 Screw holes shown in picture at right do NOT get
screws re-inserted. They are left empty.
CarShow Radio Assembly
Completed CarShow radio assembly at right
INSTALL THE CARSHOW NAVIGATION SYSTEM
You will need to prepare the CarShow Navigation System for installation in the vehicle.
Prepare the Vehicle side harnesses for
connection to the CarShow Harness
Use care not to pinch or damage cables as this will
cause performance issues/failures
Connect GPS Antenna
The GPS Harness must be tightened with a WRENCH to
ensure it is properly seated.
Failure to follow this step may result in poor GPS signal
CarShow
Installation Guide
STEP
7
CAUTION
Copyright 2013 All Rights Reserved
CS-MUST-IG Rev A
Page 10
Advertisement
