Operating Q-Bt3 - Q Acoustics Q-BT3 Instructions Manual

Operating Q-BT3

POWER AND STANDBY
Power on Q-BT3 at the AC SWITCH once all rear panel audio connections are made. The speakers will enter
STANDBY, with a RED status LED.
Exit STANDBY by pressing the STANDBY button on either the top panel or the IR remote. The LED will
initially turn Green but may then change according to the Auto-Source Selection rules.
AUDIO SOURCE SELECTION
In normal operation Q-BT3 will automatically select the audio source. A Connected Bluetooth source that
starts to play has the highest priority, followed by Digital and finally Analogue:
The AUDIO SOURCE auto-priority can be manually overridden at any time using SOURCE SELECT on the IR
remote or by a short press of the
If NO input signals are detected, Q-BT3 will automatically enter STANDBY after 20 minutes.
Important note:
When the Source button is used on the Remote Control Q-BT3 will stay on the selected source and stop auto-source
selection. Auto-source selection will be resumed after the unit has been put in standby.
SOURCE VOLUME CONTROL
Audio sources will initially be set at a DEFAULT volume level. This source can be adjusted for each source
using the VOL + and VOL – buttons on the top panel or IR remote. Once adjusted, the Q-BT3 will remember
the manually adjusted volume level for each source, and will return to the previously entered listening level
each time that source is selected.
Bluetooth
Optical input
Line in 2
Line in 1
Standby
button.
INPUT
PRIORITY
13
Instructions