Remote Control - Q Acoustics Q-BT3 Instructions Manual

Remote Control

1. Power
Press this button to turn the Q-BT3 Standby ON/OFF.
(POWER SWITCH on the rear panel must be switched to ON)
2. Source Select
Press this button to manually select the audio input source.
Status LED will change colour accordingly.
Important note:
When the Source button is used Q-BT3 will stay on the selected
source and stop auto-source selection. Auto-source selection will
be resumed after the unit has been put in standby.
3. Volume Up / Down
Press VOL + to increase the volume. Press VOL – to reduce
the volume.
4. Mute
Press this button once to MUTE the Q-BT3 (no audio output
from the speakers). Status LED will SLOW FLASH to indicate
MUTE. Press this button again to un-mute the Q-BT3 (audio
output from the speakers).
Note: Long press of Mute will also put Q-BT3 into standby.
REMOTE CONTROL BATTERY REPLACEMENT
Caution:
When replacing the lithium battery in the remote, make sure that the replacement battery is inserted in correct polarity.
Place the battery so that it's positive (+) side faces up with the tray held so the surface with the dot and (+) is facing up.
1. Push small tab toward
battery slot.
Caution:
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent battery type (CR2025)
Warning:
Do not expose batteries to excessive heat such as direct sunlight, fire or the like.
Dispose of dead batteries in accordance with local regulations.
2. Pull battery drawer out.
11
Instructions
3. Insert battery with "+"
side up and slide drawer
back into remote.
1
2
3
4