Operation - Makita HR3200C Instruction Manual

Installing or removing the bit
2
1
003150
Clean the bit shank and apply bit grease before installing
the bit.
Insert the bit into the tool. Turn the bit and push it in until it
engages.
1
2
008543
If the bit cannot be pushed in, remove the bit. Pull the
chuck cover down a couple of times. Then insert the bit
again. Turn the bit and push it in until it engages.
After installing, always make sure that the bit is securely
held in place by trying to pull it out.
To remove the bit, pull the chuck cover down all the way
and pull the bit out.
1
2
008544
Bit angle (when chipping, scaling or
demolishing)
1
2
3
008545
1. Bit shank
2. Bit grease
1. Bit
2. Chuck cover
1. Bit
2. Chuck cover
1. Change lever
2. Lock button
3. Pointer
7
The bit can be secured at 24 different angles. To change
the bit angle, depress the lock button and rotate the
change lever so that the pointer points to the
Turn the bit to the desired angle.
Depress the lock button and rotate the change lever so
that the pointer points to the
that the bit is securely held in place by turning it slightly.
Depth gauge
1
008546
The depth gauge is convenient for drilling holes of
uniform depth. Loosen the clamp screw and adjust the
depth gauge to the desired depth. After adjusting, tighten
the clamp screw firmly.
NOTE:
The depth gauge cannot be used at the position
•
where the depth gauge strikes against the gear
housing/motor housing.
Dust cup
001300
Use the dust cup to prevent dust from falling over the tool
and on yourself when performing overhead drilling
operations. Attach the dust cup to the bit as shown in the
figure. The size of bits which the dust cup can be
attached to is as follows.
Dust cup 5
Dust cup 9
003187

OPERATION

CAUTION:
Always use the side grip (auxiliary handle) and
•
firmly hold the tool by both side grip and switch
handle during operations.
symbol. Then make sure
1. Depth gauge
2
2. Clamp screw
1. Dust cup
1
Bit diameter
6 mm (1/4") - 14.5 mm (9/16")
12 mm (15/32") - 16 mm (5/8")
symbol.