Cleaning The Interior Of The Oven; Replacing The Oven Light; 5- Cleaning And Maintenance Of Your Product - Prima LPR9000 Operating And Installation

PART 5: CLEANING AND MAINTENANCE OF YOUR OVEN
5.1. CLEANING
Before starting to clean your oven, be sure that all control buttons are off and your appliance
is cooled off. Unplug the appliance.
Do not use cleaning materials containing particles that might scratch the enamelled and
painted parts of your oven. Use cream cleaners or liquid cleaners, which do not contain
particles. As they might harm the surfaces, do not use caustic creams, abrasive cleaning
powders, rough wire wool or hard tools. In the event of excess liquids spilling over onto the
oven and burning, these may cause damage to the enamel and should be cleaned
immediately. Do not use steam cleaners for cleaning the oven.

Cleaning the interior of the oven

Make sure to unplug the oven before starting to clean it. You will obtain best results if you
clean the oven interior while the oven is slightly warm. Wipe your oven with a soft piece of
cloth dampened with soap water after each use. Then wipe it again, this time with a wet cloth,
and wipe it dry. For product with catalytic enamel frames, the rear and side walls of the inner
frame do not require cleaning. However; depending on usage, it is recommended that you
replace them after a certain period of time.
5.2. MAINTENANCE

Replacing the Oven Light

The change of oven lamp must be done by an authorized technician. The rating of the bulb
should be 230V, 25Watt, Type E14,T300 before changing the lamp,the oven should be
turned off and it should be cool.
The lamp design is specific for the use in household cooking appliances and it is not suitable
for household room illumination.
17