Fns Adjusting The By-Pass Gate (Fs-110/210) - Konica Minolta 7155 Service Manual

[13] FNS adjusting the by-pass gate
4
(FS-110/210)
1. Tool
• Screwdriver (Phillips)
• Scale
2. Adjustment method
a. Preparation
Step
Open the front door.
1
Draw out the stacker unit.
2
Remove the 2 screws securing the rail
stopper, and pull out the stacker unit
even further.
Caution: To prevent the finisher from
3
Stacker unit
Board to prevent the Finisher
from toppling over
Open the by-pass conveyance guide
4
plate.
MODEL
7155/7165/7255/7272
Operation
toppling over, place a board or
the like to support the pulled-
out unit.
Rail stopper
securing screw
MANUAL
SERVICE MANUAL
Step
When the by-pass gate (SD705) is OFF,
check the gap between the by-pass gate
and the by-pass conveyance plate is
within the standard value.
Specifications: A=3.2
5
If the gap is not within the standard
6
value, perform the following adjustment.
REVISED EDITION DATE
Dec. 2003
4
OTHER ADJUSTMENT
Operation
±
0.5mm
By-pass gate
By-pass
conveyance plate
By-pass gate
PAGE METHOD
1-113 REPLACEMENT