Display Codes - Haier HNS1460TVE-FD User Manual

18

DISPLAY CODES

DISPLAY CODES AND SPECIAL FUNCTIONS
CODES CAUSES
Err1 ¬ Door is not properly shut.
Err2 ¬ Drainage error, water not emptied within 6
minutes.
Err3 ¬ Temperature sensor not properly connected or
damaged.
Err4 ¬ Heater error (Appears at the end of a cycle).
Err5 ¬ Water level not met in 8 minutes.
¬The height of the drain hose is below 80 cm.
¬ The drain hose is in water.
Err7 ¬ Motor overheat protection or damage.
Err8 ¬ Water exceeds protective level.
End ¬ End of wash cycle.
1:25 ¬The remaining time is 1 hour 25 minutes.
Unb ¬ After the last rinsing cycle fi nishes, spining fails
completely due to an imbanlance of the laundry.
Alarm sound option:
Alarm sound can be cancelled if it is needed,Please follow the instruction as below:
Switch on the washing machine and turn the program knob to spin cycle,then press the delay button and spin speed button
and hold on for 3 seconds.The "bEEP oFF" will be displayed on the screen which indicates that alarm sound has been
cancelled. To operate the above steps again,the display will show "bEEP on" and the alarm sound can be recovered.
¬ Control panel lock function: Press the "Delay" and the "Temperature" buttons simultaneously for 3 seconds after starting a program.
It can no longer be changed by operating buttons or knobs. To unlock press the "Delay" and "Temperature" buttons again for 3
seconds.
¬ Power-off memory function: In case of abrupt power failure or the need to cut off the power during a program cycle, the present
settings will be saved and the preset operation will resume when the power is on again.
¬ To cancel a program
Press the "Start/Pause" button, then switch off the power and the program is automatically cancelled. Turn the program selector
again to choose another program.
MAINTENANCE
SOLUTIONS
_ Shut the door properly.
_ Clean the fi lter and check the drain hose for blockage. If error
still exists, please contact the maintenance personnel.
_ Contact the maintenance personnel.
_ Reduce load and then start washing again. If problem still
exists, please contact the maintenance personnel.
_Make sure that tap is turned on, and water pressure is normal.
If problem still exists, please contact the maintenance personnel.
_ Install drain hose within 80-100 cm of height.
_ Make sure the drain hose is not in water.
_ Contact the maintenance personnel.
_ Contact the maintenance personnel.
_ Redistribute laundry to banlance the drum.