Moving The Machine; Display Codes - Haier Hwf80Bw1 User Manual

Maintenance
Water inlet valve and inlet valve
To prevent blockage to the water supply by ingress of foreign
substances, clean the water inlet valve and inlet valve

Moving the machine

Remove the back cover.
Remove the blanking plugs.
Tighten the bolts with a spanner.
Replace the back cover.
Long periods of disuse

Display Codes

Codes Causes
E1
6 minutes.
Door is not properly shut.
E2
F3 Temperature sensor not properly
connected or damaged.
F4 Heater error (Appears at the end of a
cycle).
E4 Water level not met in 8 minutes .
The height of the drain hose is below 80
cm.
The drain hose is in water.
r
regularly.
Clean the filter and check the drain hose
contact the maintenance personnel.
Shut the door properly, and then press the
Contact the maintenance personnel.
Contact the maintenance personnel.
Make sure that tap is turned on, and water
pressure is normal.
maintenance personnel.
Install drain hose within 80-100 cm of
height.
Make sure the drain hose is not in water.
17