Remote Control Auto Find - Zenith H27H49S Installation Manual

Remote Control Auto Find

If Programming the Remote did not find the code, try this procedure to
automatically find the code for the device. If the remote becomes inopera-
ble, go back to "Programming The Remote" and enter the Zenith TV code
(001) for Step 5, see page 60.
1
Turn On the device you're programming the
remote control to operate.
Press and hold the PRG key 2.5 seconds
2
until the Red LED indicator light stays On.
Press the key for the device you're trying to
3
program (CABLE, VCR, AUX, TV). Red LED
will blink.
Press Channel Up or Channel Down to send
4
a power On/Off code. Red LED will blink
with each press. Repeat until the device
turns Off. (This is a trial and error process,
so it may be necessary to repeat these
steps until the remote finds the code.)
5
Press ENTER to save the code. Red LED will
blink twice and exit search mode.
6
Press POWER to turn the device back on.
You can quickly get out of Auto Find by
pressing ENTER.
If the LED indicator light stays On while you
push Power, instead of turning Off, all the
codes have been tried and the device can't
be programmed.
2
Red LED
POWER
PRG
VCR
CABLE AUX TV
AUDIO
FLASHBK MUTE
CHANNEL
VOLUME VOLUME
CHANNEL
1 2 3
4 5 6
7 8 9
0
ENTER
MENU
TV/VCR
RECORD PAUSE TIMER
SOURCE
PLAY
REWIND FFWD
STOP
6
3
4
4
5
Page 61