Remote Control Mode Programming - Zenith H27H49S Installation Manual

Remote Control Device Programming
Programming the remote to operate a variety of Audio/ Video devices
1
The device you want to program the remote
to operate should be turned On.
2
Refer to the brand programming codes on
pages 63 - 67 to find the type of product
and brand name of the device you're pro-
gramming the remote to operate. Write
down the three-number codes.
3
Press and hold the PRG key. (It's recessed so
it doesn't get pushed accidentally.) When
the Red LED (indicator light) turns On,
release the key.
4 Press the mode key of the type of device
you want the remote to control (VCR, CABLE,
AUX, TV). Red LED blinks.
5 Using the NUMBER keypad, enter the three-
number code found on the charts on pages
63 - 67. Red LED blinks.
6
Press ENTER to save the code The Red LED
indicator light will blink two times and turn
Off if the code was accepted.
7
Point the remote at the device and push the
POWER key. The device should turn Off. If
not, try the other codes listed and continue
from Step 3.
Programming the Zenith remote will allow
you to use one remote to work up to 4 differ-
ent devices, if all remote operating modes are
programmed!
Not all devices can be controlled by the
Zenith remote.
Page 60
3
Red LED
POWER
PRG
CABLE VCR AUX TV
AUDIO FLASHBK MUTE
CHANNEL
VOLUME VOLUME
CHANNEL
1 2 3
4 5 6
7 8 9
0
MENU ENTER
TV/VCR
PAUSE
RECORD TIMER
SOURCE
PLAY
REWIND FFWD
STOP
7
4
4
5
6