Remote Control Auto-Find - Zenith C13A03D Instruction Manual

Remote Control Auto-Find

If Programming the Remote did not find your code, try this procedure to automatically find the code
for your device. If your remote becomes inoperable, go back to "Programming your Remote" and
enter the Zenith TV code for step five
1
Turn on the device you want the remote to control.
2 Press and hold PRG until the indicator light turns on,
then release PRG.
3
Press the key for the device you are trying to pro-
gram (CABLE, VCR, AUX, TV).
4
Press 0-0-0 (zero-zero-zero), then press ENTER right
away.
5 Point the remote at the correct device and push the
POWER key (The indicator light will turn off while
the POWER key is pressed). Allow a second to pass,
then push the POWER key again. Repeat until the
device turns off.
6
Push ENTER to save the code (The indicator light will
flash 3 times and then turn off).
7
Press POWER to turn the device back on.
You can quickly get out of Auto Find by pressing QUIT.
If the indicator light stays on while you push Power, instead
of turning off, all the codes have been tried and the device
can't be programmed.
P A G E 4 0
2
PRG
Indicator Light
CABLE VCR
SURF
FLASHBK
CHANNEL
VOLUME
CHANNEL
1
4
7
4
0
MENU
RECORD PAUSE
PLAY
REWIND
STOP
5/7
POWER
AUX TV
MUTE
VOLUME
2 3
5 6
8 9
ENTER
QUIT
TV/VCR
TIMER
SOURCE
FFWD
3
6
206-3643