Table of Contents
Advertisement
Quick Setup
1) Make sure the SignalBoost is
mounted vertically on its
stand.
2) Plug the Ethernet cable into
the LAN socket and the
power cable into the into
the 9V DC socket of your
nano3G AP.
3) Plug the other end of the
Ethernet cable into a free
socket on your broadband
router or Ethernet switch.
In case of difficulty at this
point, see page 9 for help.
4) Plug the mains adaptor into a
suitable power outlet.
5) Stand the SignalBoost vertically in the desired location and, if necessary,
switch on power at the mains outlet.
6) Wait for the SignalBoost to start providing service. At this point, the 3G
LED will be constantly lit green
7) Use your phone as normal.
This should normally take about 10 minutes, but may
take up to 2 hours.
(no flashing).
7
Advertisement
Table of Contents
