Box Contents ...................6 Connectors ..................6 LED Lights ..................6 Quick Setup ..................7 Help With SignalBoost AP Setup ............8 Network And Broadband Requirements ........... 8 Fast Broadband Service ..............8 Available Network Connection ............. 9 IP Address For Your SignalBoost............ 9 Placement Of Your SignalBoost ............
• Do not use the SignalBoost near flammable or explosive sub- stances. Heat from SignalBoost may cause these substances to ignite. • Do not put any objects through any openings on the SignalBoost or its mains adaptor. Failure to do so may result in fire or electric shock.
Page 4
SignalBoost im- mediately and do not operate until completely dry. • Do not disassemble the SignalBoost or its mains adaptor for any reason. • Do not attempt to power the SignalBoost with any power adapter other than the one included with your device.
Types of devices include: 3G mobile phones, 3G dongles for laptops, tablets/pads with 3G capability. Up to 8 of these can use your SignalBoost for communication at the same time. Only devices that obtain 3G services from the same mobile ser-...
Internet via your home net- work. LED Lights Your SignalBoost has three LED lights that use colours and flashing to show Power, Ethernet and 3G service status. For more information, please see About The LEDs On Your SignalBoost on page 12.
5) Stand the SignalBoost vertically in the desired location and, if necessary, switch on power at the mains outlet. 6) Wait for the SignalBoost to start providing service. At this point, the 3G LED will be constantly lit green (no flashing).
Internet download bandwidth, which may prevent your SignalBoost from providing optimal service. The SignalBoost requires an “always on” Internet connection. Switch- ing off your broadband router and/or modem will stop your Signal- Boost from providing service.
As this type of broadband modem has only one Ethernet socket on the home network side, it is not recommended to plug the SignalBoost directly into the broadband modem, as this will exclude connections to any other devices on your home network.
3G devices most frequently. CAUTION Ensure that the Signalboost cables are out of the way of high traffic areas, chil- dren and household pets to avoid choking, tripping, or damage to the cables and the nano3G AP.
About The LEDs On Your Signalboost The three LED indicators on the front of your Signalboost case show what is hap- pening with your nano3G AP. Unit is not switched on. Green Unit is powered up normally. Flashing green Self-test is running.
Can I switch off my Signalboost when I am not using it? The Signalboost is designed to be switched on at all times. If you switch off your Signalboost for any reason, you may have to wait for it to provide service when you switch it back on again.
This may happen if the sensed hardware temperature is too high. Make sure back to red after the Signalboost is not located near a heat source and is not in an enclosed turning green space with restricted air flow. Try disconnecting power and allow the unit to cool, then reconnect power.
General Information Firewall Settings Protocol Ports 500 and 4500 IPSec. Secures the connection to your mobile service provider’s servers. 80 and 443 CRL Download. For downloading security validation files. DNS. For resolving the route to your mobile service provider’s servers. NTP.
General Notices CASE SHALL IPACCESS LTD BE LIABLE FOR ANY SPECIAL, INCIDENTAL, INDIRECT, OR CONSEQUEN- TIAL DAMAGES, OR INCIDENTAL, INDIRECT, OR Notice CONSEQUENTIAL DAMAGES, OR LOST PROFITS, Some features of the product and its accessories BUSINESS, REVENUE, DATA, GOODWILL OR ANTICI- described herein rely on the software installed, PATED SAVINGS.
EU Regulatory Compliance Regulatory Notices Models nano3G 237A and 237AA conform to the US FCC Compliance following regulatory standards: FCC CFR47 Part 15B: Variants 237B, BA, C, CA • Health EN50385: 2002 FCC CFR47 Parts 22, 24: Variants 237B, BA •...
Company Information ip.access Limited is a Private Limited Company Regis- tered in England and Wales Company No. 03400157 Registered Office: Building 2020 Cambourne Business Park Cambourne CB23 6DW Tel: +44 (0) 1954 713 700 Fax: +44 (0) 1954 713 799 Further company information may be found at: www.
Page 18
SignalBoost User Guide Version 1.01 April 2013 Please Call Batelco on 196 For more information...