Parent Unit Battery Led Indicator; Find - BT Baby Monitor 300 Setup & User Manual

16 Using your BT Digital Baby Monitor 300
Do not press the
when the Baby unit and
Parent unit are positioned in
the same room. High-pitch
noise will be generated if the
button is pressed when the
Baby unit and Parent unit are
close to each other or within
3 metres distance.
When using Talk back, hold
the Parent unit approximately
30cm in front of your mouth
when talking to baby.
If you experience any problems, please call the Helpline on Freephone 0800 145 6789* or visit bt.com/producthelp
2250 Baby Monitor 300 UG Iss2.[2].indd 16
button
1. Press and hold down the
unit to speak to your baby.
Whilst the
indicators will flash on both units.
Parent unit battery LED indicator (top of unit)
When the Parent unit is on charge, the battery LED
will be solid red. When the power is removed, the
LED will switch off. When the battery is low, the LED
will flash.

Find

You can press the
make the Parent unit sound an alert beep to help
you find it if it's been misplaced. If the Parent unit
loudspeaker volume had been muted (or set to
volume off), the volume level will be reset to the
default setting of Level 3.
1. Press
sound at the Parent unit.
2. To stop the alert, press any button on the Parent
unit or press the
If no button is pressed after 2 minutes then the
alert will automatically stop.
button on the Parent
button is depressed the green Link
button on the Baby unit to
on the Baby unit. The paging alert will
button again on the Baby unit.
10/04/2014 11:06