Motorola VIP 1910 Installation Instructions And Manual page 31

Video output
o
The "video output" menu enables setting up the video outputs of the set-top box – how you
will connect the television set. There are three items in this menu:
Video output – Select the used video output (connector used to connect the set-top box to
the television set. There are two options: SCART and HDMI / Component. Select the one
which your television set is equipped with. If it has both, select HDMI.
Video standard – set up how signal is transmitted via the abovementioned connector.

For SCART, select RGB, S-Video or CVBS. (The scart connector can transmit
signal in various ways – it is actually several connectors integrated into one).
RGB has the best quality, followed by S-Video and CVBS (common composite
signal). Select according to the capabilities of your television set.

In the case of the HDMI connector (digital high definition) or Component (analog
high definition – three round connectors Y, Pb and Pr), it is necessary to define
the quality of the resolution – either HD ready (720p) or full HD (1080i) – see the
television set manual. You can also select standard 576p resolution (standard
PAL in digital quality).
The HDMI output may also be set up according to article 8 of this manual.
Color systems (Video standard) – necessary to set up only for the SCART connector.
Select PAL. For HDMI or Component, sRGB is automatically selected.
Do not forget to save your settings.
.
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
Screen centering
o
Shift of the picture (if it is not directly in the middle) to the left / to the right / up /down.
The shift is performed using the cursor arrow key (fine shift) or using the PAN arrows
(coarse shift in big steps).
Info
o
Displays basic information on the set-top box – its serial number, IP and MAC address,
etc. For the purpose of the standard operation, it is not relevant for a common user.
viaTV_STBmanual_M1910_EN.doc Page 31 (Total 38)