Using The Ac Adaptor - Panasonic Lumix DMC-G1K Operating Instructions Manual

Using the AC Adaptor

You can use the camera without worrying about battery discharge when it is connected to
a PC or a printer if you use the DC cable (DMW-DCC3; optional) to connect the camera to
the battery charger/AC adaptor (supplied) and connect the AC mains lead.
•
Check that the camera is turned off.
•
Close the flash.
Connect the AC mains lead.
Connect the DC cable A.
•
Pull open the DC cable cover 1 and then
connect the DC cable to the camera body using
the same steps as "Inserting/Removing the
Battery" (P23). Pull the DC cable through the
opening as shown in the illustration and then
close the battery door.
• Be careful not to catch the DC cable when
closing the battery door.
• You cannot charge the battery if you connect the
DC cable (DMW-DCC3; optional).
Note
•
Be sure to use the supplied AC cable and the prescribed DC cable (DMW-DCC3; optional)
when using the battery charger/AC adaptor (supplied) as an AC adaptor.
•
The camera becomes warm during use. This is not a malfunction.
•
Disconnect the charger/AC adaptor and DC cable when the camera is not in use.
•
The unit is in the standby condition when the AC adaptor is connected. The primary circuit is
always "live" as long as the AC adaptor is connected to an electrical outlet.
Others
133
VQT1U44