P [Protect] - Panasonic Lumix DMC-G1K Operating Instructions Manual

Note
•
The number of prints can be set from 0 to 999.
•
With a printer supporting PictBridge, the date print settings of the printer may take precedence
so check if this is the case.
•
It may not be possible to use the DPOF print settings with other equipment. In this case, cancel
all the settings, and reset the settings.
•
If the file is not based on the DCF standard, the DPOF print setting cannot be set.
You can set protection for pictures you do not want to be deleted by mistake.
Select [PROTECT] on the [PLAYBACK] mode menu. (P28)
Press 3/4 to select [SINGLE] or [MULTI] and then
press [MENU/SET].
Select the picture, and then
press [MENU/SET].
When [MULTI] has been selected
• Repeat these steps for each picture.
•
The settings are cancelled when [MENU/
SET] is pressed again.
Press [‚] to return to the menu screen.
•
Press [MENU/SET] to close the menu.
∫ Cancelling all the [PROTECT] settings
1 Select [CANCEL] on the screen shown in step
Press 3 to select [YES] and then press [MENU/SET].
2
3 Press [MENU/SET] to close the menu.
•
If you press [MENU/SET] while cancelling protection, the cancelling will stop halfway.
Note
•
The protect setting may not be effective on other equipment.
•
Even if you protect pictures on a card, they will be deleted if the card is formatted.
•
Even if you do not protect pictures on an SD Memory Card or an SDHC Memory Card, they
cannot be deleted when the card's Write-Protect switch is set to [LOCK].

P [PROTECT]

[SINGLE]
Press 2/1 to select
the picture.
2
and then press [MENU/SET].
Advanced (Playback)
[MULTI]
Press 3/4/2/1 to
select the pictures.
115
VQT1U44