Table of Contents
Advertisement
5 UNDER SCAN button
Reduces the screen size so that the whole screen is
displayed.
6 BLUE CHECK button
Displays the blue video signal only.
7 COLOR OFF button
Displays the luminance signal only.
8 INPUT SELECT buttons/lamps
Select an input to display.
A: Select the video and audio signals input to the
VIDEO A and AUDIO A terminals.
B: Select the video and audio signals input to the
VIDEO B and AUDIO B terminals.
• The corresponding lamp of the input currently
selected lights up.
9 DC INDICATOR lamp
Turns to orange from green when the DC power
voltage lowers. When the voltage becomes lower
than the certain level, the monitor automatically
turns off and the lamp turns to red.
• Make sure to turn off the DC switch on the rear
panel before replacing the battery.
• The length of time the lamp lights in orange differs
depending on the type of the battery or the battery
condition.
It is recommended to replace the battery when the
lamp turns to orange.
p Power lamp
Unlit:
The AC or DC switch on the rear panel is
off.
Orange: The AC or DC switch on the rear panel is
on and the monitor is in stand-by mode.
Green: The monitor is on.
q Stand-by button
Turns on and off the monitor when the AC or DC
switch on the rear panel is on.
NOTE:
• When using the DC power supply, turning on the DC switch
on the rear panel puts the monitor in stand-by mode. To
turn on the monitor, press the stand-by button.
7 About the status display
Displays information of the current input selection
and the monitor settings for about 3 seconds.
To show the status display, set "STATUS DISPLAY"
to "AUTO" or "MANUAL" beforehand.
☞ "STATUS DISPLAY" on page 13
Pressing the INPUT SELECT button currently
selected shows the status display.
NOTE:
• When "STATUS DISPLAY" is set to "AUTO," the status
display also appears on the screen if you change the
inputs or the signal condition changes.
1 Signal format
• "NO SYNC" is displayed when no video signal
is input.
• "Out of range" is displayed when a
noncompliant signal is input.
2 Setting of "COLOR TEMP."
☞ "COLOR TEMP./BAL." on page 12
" * " is displayed if white balance is adjusted in the
"COLOR TEMP./BAL." menu.
3 Setting of UNDER SCAN
☞ "5 UNDER SCAN button" on the left column
OVER:
Over-scan
UNDER: Under-scan
4 Setting of BLUE CHECK
☞ "6 BLUE CHECK button" on the left column
NORMAL: Normal screen
B ONLY:
Blue screen
5 Setting of COLOR OFF
☞ "7 COLOR OFF button" on the left column
COLOR: Normal screen
MONO:
Monochrome screen
5
Hide quick links:
Advertisement
Table of Contents
