Hummer 2010 H3 Owner's Manual page 34

2-8 Keys, Doors and Windows
2. Lift up slightly on the entire
tailgate assembly.
Remove the retaining cables
from both sides of the pickup
box by pulling the clips away
from the bolt heads while
pushing the cable bracket
forward. When the larger part of
the hole on the bracket is over
the bolt, slide the bracket off of
the bolt.
3. With the tailgate partially down,
lift up on the passenger's side
and pull the tailgate toward you,
then move the tailgate to the
right to release the driver's side.
Reverse the procedure to reinstall
the tailgate. Make sure it is secure.
Ofrecido por www.electromanuales.com
To partially lower the tailgate:
1. With the tailgate fully open, lift
up slightly on the entire tailgate
assembly.
Tailgate Partially Down
2. Remove the retaining cable from
the passenger side of the pickup
box by pulling the clip away from
the bolt head while pushing the
cable bracket forward.
When the larger part of the hole
on the bracket is over the bolt,
slide the bracket off of the bolt.
3. Slide the lower end fitting onto
the front bolt. The tailgate will
now stay in the partially opened
position.
4. Repeat Steps 2 and 3 for the
driver side.
When closing the tailgate the
bracket cannot be in the partially
opened position. It must be
anchored on the rear bolt using
the top position on the bracket.
Swing-gate (H3)
To lock or unlock the swing gate,
use the power door lock switch or
the Remote Keyless Entry (RKE)
transmitter.
WARNING
Make sure the swing gate is
completely closed. Driving with
the swing gate open could injure
pedestrians or damage the
vehicle.