Hazard Warning Flashers; Turn And Lane-Change; Signals - Hummer 2010 H3 Owner's Manual

Ofrecido por www.electromanuales.com
During that delay, the instrument
panel cluster may not be as bright
as usual. Make sure the instrument
panel brightness control is in the
full bright position. See Instrument
Panel Illumination Control on
page 6 7.

Hazard Warning Flashers

|
(Hazard Warning Flasher):
Press this button located on the
instrument panel, to make the front
and rear turn signal lamps flash on
and off. This warns others that you
are having trouble.
|
Press again to turn the
flashers off.

Turn and Lane-Change

Signals

An arrow on the instrument panel
cluster flashes in the direction of the
turn or lane change.
Move the lever all the way up or
down to signal a turn.
Raise or lower the lever until the
arrow starts to flash to signal a
lane change. Hold it there until the
change is completed.
Lighting
The lever returns to its starting
position whenever it is released.
If after signaling a turn or a lane
change the arrow flashes rapidly or
does not come on, a signal bulb
may be burned out.
Have the bulbs replaced. If the bulb
is not burned out, check the fuse.
For bulb replacement, see Bulb
Replacement on page 10 35. For a
blown fuse or circuit breaker, see
Fuses and Circuit Breakers on
page 10 39.
Turn Signal On Chime
If a turn signal is left on for more
than 3/4 of a mile (1.2 km), a chime
sounds at each flash of the turn
signal and the message TURN
SIGNAL will also appear in the DIC.
To turn the chime and message off,
move the turn signal lever to the off
position.
See TURN SIGNAL under Lamp
Messages on page 5 24.
6-5