Hummer 2010 H3 Owner's Manual page 176

7-22 Infotainment System
Using the Call Command
1. Press and release . The
system responds with Ready
followed by a tone.
2. Say Call . The system responds
with Call using <phone name>.
Please say the name tag
followed by a tone.
3. Say the name tag of the person
to call.
If the system clearly
recognizes the name tag it
responds with OK, calling,
<name tag> and dials the
number.
If the system is unsure
it recognizes the right
name tag, it confirms the
name tag followed by a
tone. If the name tag is
correct, say Yes .
Ofrecido por www.electromanuales.com
The system responds with
OK, calling, <name tag>
and dials the number. If the
name tag is not correct, say
No . The system will ask
for the name tag to be
re entered.
Once connected, the person called
will be heard through the audio
speakers.
Using the Re dial Command
1. Press and release
system responds with Ready
followed by a tone.
2. After the tone, say Re dial . The
system responds with Re dial
using <phone name> and dials
the last number called from the
connected Bluetooth phone.
Once connected, the person called
will be heard through the audio
speakers.
Receiving a Call
When an incoming call is received,
the audio system mutes and a ring
tone is heard in the vehicle. Press
and release
Call Waiting
Call waiting must be supported on
the Bluetooth phone and enabled by
the wireless service carrier to work.
Press and release
. The
an incoming call when another
call is active. The original call is
placed on hold.
Press and release
return to the original call.
To ignore the incoming call,
continue with the original call
with no action.
to answer the call.
to answer
again to