Setup For Input Signals; Component / Rgb-In Select - JVC GD-V422U Instructions Manual

Setup for Input Signals

Component / RGB-in Select

Select the input signals to be connected by installing the Optional Video Input Card.
(Refer to the Operating Instructions for the optional Video Input Card.)
Select to match the signals from the source connected to the Component / RGB input terminals.
Y, P , P signals
B R
R, G, B, HD, VD signals
INPUT
SURROUND
VOL
N
PICTURE SOUND SET UP
MULTI ZOOM
SWAP SELECT MOVE
PIP
Note:
Selection may not be possible, depending on which optional board is installed.
3D Y / C Filter
Select "Signal" from the "Setup" menu during AV(S Video) input signal.
("Signal [AV]" menu is displayed.)
R
Note:
When On, this setting only affects NTSC input signals.
30
"Component"
"RGB"
1
2
R
– For NTSC AV images
Press to select the "3D Y / C Filter (NTSC)".
Press to set On / Off.
Press to exit from adjust mode.
SET UP
Press to display the Setup menu screen.
Press to select the "Component / RGB-in
Select".
Press to select the desired input signal.
R
Press to exit from adjust mode.
Setup
Component/RGB-in select
RGB
RGB1
Input label
Signal
Screensaver
Power save Off
Standby save On
Power management Off
English ( UK )
OSD Language
Component
Setup
Component/RGB-in select
RGB
Input label RGB1
Signal
Screensaver
Power save Off
Standby save On
Power management Off
English ( UK )
OSD Language
Press (ACTION) button
Signal
3D Y/C Filter ( NTSC )
On
Colour system
Auto
Cinema reality Off
Aspect Auto ( 4:3 )
4 : 3
1/2
RGB
1/2
[ AV ]