Accessories; Accessories Supplied; Remote Control Batteries - JVC GD-V422U Instructions Manual

Accessories

Accessories Supplied

Operating
Instruction book
GD-V422U
GD-V502U
Ferrite core
(small size) 1

Remote Control Batteries

Requires two AA batteries.
1. Turn the transmitter face down.
Press and slide off the battery
cover.
Helpful Hint:
For frequent remote control users, replace old batteries with
Alkaline batteries for longer life.
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Observe the following precautions:
1. Batteries should always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: "Zinc Carbon" with "Alkaline").
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5. Battery replacement is necessary when remote control acts sporadically or stops operating the Plasma Display.
8
Check that you have the Accessories and items shown
Remote Control
Transmitter
EUR646532
INPUT
SURROUND
VOL
N R
PICTURE SOUND SET UP
MULTI ZOOM
PIP SWAP SELECT MOVE
PICTURE
POS. /SIZE ASPECT
PC OFF TIMER
PLASMA DISPLAY
Ferrite core
(large size)
2. Install the batteries as shown in the
battery compartment.
(Polarity + or – must match the
markings in the compartment.)
Batteries for the Remote
Control Transmitter
(AA Battery
Fixing bands
2
Two AA size
AC cord
2)
3. Replace the cover and slide in
reverse until the lock snaps.