Truma Ultrastore Water Heater Operating Instructions - Swift Motorhomes 2013 Owner's Service And Warranty Handbook

T R U M A ULTRASTORE
Truma Heating System and Air Flow
The Swift Group undertakes considerable
testing of our products in cold chambers
to ensure they meeting the BS EN 1649
Grade 3 standard and are useable in cold
temperatures. During this testing, the air flow
on the blown air outlets (S3004 space heater
and Combi Heaters) is defined and set by
us. In some cases, customers may wish to
alter this setup to achieve a different heating
pattern (i.e. more hot air to the rear of the
vehicle or vice-versa) and this can be achieved
by altering the diverter flap (S3004 heater) or
by placing restrictors in the blown air system
(Combi units).
Customers should seek the advice of Truma or
their Dealer on how to do this
Equipment Specification
For details on type of equipment fitted in your
motorhome, please refer to the Sales Brochure
or Dealer.
Note: In all cases the electric (230v) heating
system is designed to supplement the
gas heating system. For quick / efficient /
prolonged heating gas must be used.
IMPORTANT
To maximise the use and life of all fitted
equipment in your motorhome it is essential
that any accompanying manufacturers'
literature is read fully. All recommended
maintenance and preparation procedures
should be followed. The information provided
in this handbook is only intended as a guide.
If in any doubt consult your manufacturer
appointed dealer, particularly before
attempting to install EXTRA EQUIPMENT.
Notice: In the interest of safety,
replacement parts for an appliance shall
conform to the appliance manufacturer's
specifications and should be fitted by them
or their authorised agent.
90
TRUMA ULTRASTORE
WATER HEATER OPERATING
INSTRUCTIONS
Attention: Before using for the first time, it
is essential to flush the entire water supply
through with clean warm water. Always
mount the cowl cover when the water heater
is not being operated! Drain the water heater
if there is a risk of frost!
There shall be no claims under guarantee for
damage caused by frost!
When connecting to a central water supply
(rural or city connection) or when using more
powerful pumps, a pressure reducer must be
used which prevents pressures of greater than
2.8 bar occurring in the Ultrastore.
Filling the Truma Ultrastore with water
e = Lever position
'Closed'
f = Lever position
'Drain'
Fig. 1
1. Check that the drain valve in the cold-
water intake is closed. Lever should be in
the horizontal position (e).
2. Open the hot tap in the bathroom or
kitchen with pre-selecting mixing taps or
single lever fittings set to hot.
3. Switch on power for water pump (main
switch or pump switch). Leave the tap
open to let air escape while the water
heater is filling. The heater is filled when
water flows out of the tap.
Note: residues of frozen water can prevent
filling if there is a frost. The water heater
can be defrosted by switching on the
heater for a short period (max 2 mins).
Frozen pipes can be defrosted by heating
the room.