JVC DT-V100CG Instructions Manual page 16

How to Use SET-UP MENU
HOUR METER X100h
Displays the total usage time of the monitor in
hundred-hour units.
• 000 O 655
NOTES:
• When the timer passes 655, it returns to 000.
• The timer does not count the usage time under one hour.
PICTURE SUB ADJ.
CONTRAST
• –20 O 00 O +20
BRIGHT
• –20 O 00 O +20
CHROMA
• –20 O 00 O +20
PHASE
• –20 O 00 O +20
NTSC SETUP
Sets the set-up level of the input NTSC signal.
00: Compliant with 0% set-up signal.
7.5: Compliant with 7.5% set-up signal.
COMPO. LEVEL
Sets the set-up level of the input component or SD
SDI signal.
This item appears on the menu only when using the
Multi-Format SDI Unit (option) or the Component Unit
(option).
SMPTE: Compliant with M2VTR signals.
B00: Compliant with Betacam 0% set-up signal.
B75: Compliant with Betacam 7.5% set-up signal.
16
The standard value ("00") of
the picture adjustment is
initially set at the factory.
You can adjust the standard
value as your initial setting.
• Can also be used to switch the
NTSC set-up level, and
change the component or SD
SDI signal's input level
settings.
COLOR TEMP./BAL.
COLOR TEMP.
Selects the color temperature.
HIGH: Sets the color temperature to 9300.
LOW: Sets the color temperature to 6500.
BLUE DRIVE
Adjusts the blue drive level.
• MIN O 000 O MAX (in 127 grades)
RED DRIVE
Adjusts the red drive level.
• MIN O 000 O MAX (in 127 grades)
GREEN CUTOFF
Adjusts the green cut-off point.
• MIN O MAX (in 155 grades)
BLUE CUTOFF
Adjusts the blue cut-off point.
• MIN O MAX (in 155 grades)
RED CUTOFF
Adjusts the red cut-off point.
• MIN O MAX (in 155 grades)
(cont.)
Sets or adjusts the color
temperature or white
balance.
NOTE:
Use the five items indicated with
mark to make fine adjustments
between the monitors.