Delta AH500 series Hardware Manual page 220

Error
Description
code
The signal received by
channel 2 exceeds the range
of inputs which can be
16#A402
received by the hardware.
(The ERROR LED indicator is
ON.)
The signal received by
channel 3 exceeds the range
of inputs which can be
16#A403
received by the hardware.
(The ERROR LED indicator is
ON.)
The signal received by
channel 4 exceeds the range
of inputs which can be
16#A404
received by the hardware.
(The ERROR LED indicator is
ON.)
The signal received by
channel 5 exceeds the range
of inputs which can be
16#A405
received by the hardware.
(The ERROR LED indicator is
ON.)
The signal received by
channel 6 exceeds the range
of inputs which can be
16#A406
received by the hardware.
(The ERROR LED indicator is
ON.)
The signal received by
channel 7 exceeds the range
of inputs which can be
16#A407
received by the hardware.
(The ERROR LED indicator is
ON.)
16#A600 Hardware failure
The external voltage is
16#A601
abnormal.
Internal error
16#A602
The CJC is abnormal.
Internal error
16#A603
The factory correction is
abnormal.
The signal received by
channel 0 exceeds the range
of inputs which can be
16#A800
received by the hardware.
(The ERROR LED indicator is
OFF.)
C h ap te r 9 Tro ub les ho o ti ng
Remedy
Check the module parameter in HWCONFIG.
Check whether the signal received by channel 2
exceeds the range of inputs which can be received
by the hardware.
Check the module parameter in HWCONFIG.
Check whether the signal received by channel 3
exceeds the range of inputs which can be received
by the hardware.
Check the module parameter in HWCONFIG.
Check whether the signal received by channel 4
exceeds the range of inputs which can be received
by the hardware.
Check the module parameter in HWCONFIG.
Check whether The signal received by channel 5
exceeds the range of inputs which can be received
by the hardware.
Check the module parameter in HWCONFIG.
Check whether the signal received by channel 6
exceeds the range of inputs which can be received
by the hardware.
Check the module parameter in HWCONFIG.
Check whether the signal received by channel 7
exceeds the range of inputs which can be received
by the hardware.
1. Check whether the backplane is normal.
2. Check whether the module operate normally.
Check whether the external 24 V power supply to
the module is normal.
Please contact the factory.
Please contact the factory.
Check the module parameter in HWCONFIG.
Check whether the signal received by channel 0
exceeds the range of inputs which can be received
by the hardware.
9 - 2 5