Removing / Mounting Chute Unit, Stacker Unit, Pcb Unit And Covers; Removing/Mounting The Chute Unit (Adf Paper Chute); Removing/Mounting The Stacker Unit - PFU Limited fi-5530C Maintenance Manual

4-7. Removing / Mounting Chute Unit, Stacker Unit, PCB Unit and Covers

4-7-1. Removing/Mounting the Chute unit (ADF paper chute)

Refer to Section 6-25 for the part number of the replacement part.
<Removing>
Turn the Chute unit (ADF paper chute) upward,
and Pull it out from the scanner. There is the
craw on top of tabs to hook the Chute unit
(ADF paper chute).
<Mounting>
Hold the Chute unit (ADF paper chute) and insert its tabs into
the holes on the rear side of the scanner as shown in the figure
on the right so that the side guides face up.

4-7-2. Removing/Mounting the Stacker Unit

Refer to Section 6-24 for the part number of the replacement part.
<Removing>
(1) Slide the Stacker unit to right until it
touches the side face of cover. Turn the
Stacker unit up about 45 degrees. Then
pull and detach a fulcrum part, which
touches the side face of cover.
(2) Slide the Stacker to left until tit touches
another end. Pull and detach another
fulcrum part.
<Mounting>
Follow the above procedure in reverse.
05 Nov. 20, 2008 K.Okada T.Anzai
04 July 7, 2008 K.Okada T.Anzai
03 Feb.23, 2007 K.Okada K.Okada
Rev DATE DESIG. CHECK
Aug.19, 2005
DESIG K.Okada CHECK
N
Claw
Scanner
I.Fujioka Refer to Revision Record on page 2.
I.Fujioka Refer to Revision Record on page 2.
T.Anzai Refer to Revision Record on page 2.
APPR. DESCRIPTION
K.Okada
T.Anzai
APPR.
Chute unit
ADF paper chute
Tab
Chute unit
(ADF paper chute)
Stacker unit
Fulcrum
TITLE fi-5530C/fi-5530C2
MAINTENANCE MANUAL
DRAW. P1PA03334-B30X/6
No.
PFU LIMITED
Section 4-7-1
Scanner
About 45 degree
IMAGE SCANNER
CUST.
PAGE
65 138
/