Booth Dinette; Hide A Bed; Tv Power Supply; J-Steel Sofa - Jayco 2012 Jay Feather Ultralite Owner's Manual

TOWABLE (EXPANDABLE)
Let the cord hang free. Do not route

electrical cords between the heated bed
mats and the bed boards. Do not allow the
cords to be pinched. NEVER pull a heated
bed mat by its cord.
Keep the heated bed mat control away

from an open window.
Do not use pins or any heavy, sharp

pointed objects on the heated bed mats.
They may damage the heating elements.
Be sure the heated bed mats are used on

a 120 volt AC circuit.
Turn off the electric current when this

bedding is not in actual use.
Maintenance
Do not use dry cleaning fluid on the heated
bed mats. Cleaning solvents may have a
deteriorating effect on the insulation of the
heating element.
Unplug the bed mats first. Wipe gently or blot
the soiled area, using a damp cloth treated
with a mild detergent. DO NOT IMMERSE the
heated bed mats;
thoroughly before plugging them in for use.
H -A-B (
IDE ED IF SO EQUIPPED
The hide-a-bed sofa functions much the same
as a regular residential hide-a-bed sofa. To
make the hide-a-bed sofa into a bed, remove
the seat cushions and pull the sofa back
towards you firmly and gently. Activate (or
deflate) the air mattress (if so equipped) using
the supplied furniture
instructions. To convert the hide-a-bed back
into the upright sofa position, reverse the
process .
J-S S (I S
TEEL OFA F
The J-steel sofa functions much the same as
a residential futon. To make the J-steel sofa
in to a bed, lift up on the bottom seat cushion
and pull it towards you.
allow them to dry
)
manufacturer's
E )
O QUIPPED
CAMPING & OPERATING
The sofa back will drop down to provide a
sleeping surface. For additional comfort and
to reduce fabric damage, you may want to
place a cover or air mattress (customer
supplied) over the J-steel sofa when it is in
the sleeping position.
B D (I
OOTH INETTE F
The dinette is designed to seat up to four
adults. You can access the dinette bench
storage by removing all the cushions and
lifting the bottom seat supports. If the dinette
bottom seat support is screwed shut, it is to
protect factory-installed equipment (do not
use that area for storage). To convert back to
a booth dinette, reverse the process.
The booth dinette can be converted into a
bed. To convert, remove all the cushions from
the booth dinette. Lift the tabletop, remove the
detachable table legs and place the tabletop
on the ledges provided between the booth
dinette benches. Lay the seat back cushions
against the back of the booth dinette bench.
Lay the dinette seat bottom cushions in
between the seat back cushions. The area
where the cushions meet should be slightly
raised. Push the raised cushion ends down
gently. The cushions are designed to fit
snugly. Reverse this process when converting
back to the booth dinette.
TV P S
OWER UPPLY
For good station reception, the
TV power supply must be
turned ON to view
television stations. Turning the
TV power supply ON sends
12-volt DC through the cable
to the TV roof antenna. The
voltage energizes
transistors in the
head amplifier.
Turn the TV power supply OFF
to view cable or
television, or to use a VCR or
DVD..
SECTION 10
S E )
O QUIPPED
local
the
antenna
Fig. 10.2 TV
Power Supply
satellite
10 - 3