Operating The Slideout; Retracting Slideout Room - Jayco 2012 Jay Feather Ultralite Owner's Manual

TOWABLE
Ensure that the trailer is level before
operating the slideout room. Water leaks
and other problems could result if the
slideout is operated without leveling the
trailer.
Ensure there are no people or obstructions
blocking the path of the room when it is
moving. Keep away from the slide rails
when the room is in motion. The gear
assembly may pinch or catch on loose
clothing causing personal injury.
Ensure the slideout is in the closed
position prior to hooking the unit to the tow
vehicle.
FAILURE TO
INSTRUCTIONS COULD RESULT IN
SERIOUS INJURY OR DEATH.
Do not place excessive weight in the
slideout room. It can cause the slideout
room to malfunction and cause damage to
the slideout.
The slideout room system is designed for
additional floor space and comfort. The
mechanical components are gear driven.
Electric powered slideout room systems have
a manual override to allow you to extend or
retract the slideout room(s) in case of a power
loss. Make sure you have sufficient power
available before operating your slideout
system.
O T S
PERATING HE LIDEOUT
Additional support jacks are not needed
under the slideout. Damage can occur to
your slideout room from improper use of
aftermarket support jacks.
FOLLOW THESE
SLIDEOUT SYSTEM
1. The auxiliary battery (customer supplied)
must be fully charged and connected. If
possible, the RV should be hooked up to
120-volt AC power so the converter
operates.
2. The RV must be level and the stabilizer
jacks in the extended position.
3. Locate the slideout control switch.
4. To move the room out, press the OUT
section of the switch and hold it until the
motor stops (travel time is approx. 25
seconds). Operating the switch after the
room is fully extended will damage the
switch and motor.
After the slideout is extended, verify that the
corners of the black rubber seal are set up
correctly. The corners of this seal are cut at a
45° angle. The top of the seal must overlap
the side of the seal to avoid the possibility of
water penetration.

Retracting slideout room

Press the IN section of the slideout control
switch and hold it until the motor stops.
Operating the switch after the room is fully
retracted will damage the switch and motor.
SECTION 9
Fig. 9.1
slideout
control
switch
Fig. 9.2
Exterior
slideout room
corner
9 - 1