Columbia Coronado 25 Owenrs Manual page 89

6_.2.2 (continued)
siderably, giving it an almost like new shine. For maximum
satisfaction after you have repaired a hole or fracture, buff
the entire unit, not just the repaired area.
Heavy duty polisher
Buffing pad
White cloth
B. Cleaning the Surface
1. Saturate a cloth with acetone.
2. Wipe the surface of the fiber glass unit with the saturated
cloth to remove all loose debris. If not removed, debris can
scratch the finish during buffing.
3. Repeat Step 1 as necessary to remove all debris.
C. Huffing the Surface
1. Attach buffing pad to a heavy duty polisher
and apply harsh grit buffing compound to the pad.
2. Holding the polisher at a 95 degree angle, buff the unit with
just enough pressure to remove grease, grit, and grime.
CAUTION:
3. Holding the polisher flat on the surface and applying very light
pressure, buff the unit to restore the gloss and remove slight
scratches.
4. To remove heavier scratches, see Section 6.2.3.
_6.2.3 Removing Scratches
Heavy duty polisher
Huffing pad
White cloth (2)
Sanding block
TOOLS
APPLY MINIMUM PRESSURE TO CORNERS AND EDGES SO AS NOT TO
REMOVE THE GEL COATING.
TOOLS
SECTION 6
Page 9
MATERIALS
Harsh grit buffing compound
Acetone
Water
MATERIALS
Harsh grit buffing compound
Acetone
Water
Sandpaper, 200,900,600 grit