Electrical System - Columbia Coronado 25 Owenrs Manual

5.14 Electrical System - 12 Volt DC
The lighting wiring harness is molded in the deck liner in most
boats. All connections should be with Stak-on type connectors and
terminal wiring eyes. All wiring harnesses should be bundled and
wrapped with plastic ties every 19". Care should be taken to route
all cable bundles up out of the bilge so bilge water cannot get to
them. For connections to bilge pumps and other bilge mounted
electrical devices the connection should be well up out of the bilge.
The mast wires come through the mast step and are secured to a
female plug. A male plug is wired in the same manner to the mast
wiring so the mast can be disconnected easily when unstepped.
Secure wires to the Master Control Panel in accordance with the wiring
diagram, using ring type stak-on terminals.
SECTION 5
Page 28